Cadillac XT5 2017 Owner's Manual page 192

the Remote Keyless Entry (RKE)
system. See Remote Keyless Entry
(RKE) System Operation 0 27.
To shift out of P (Park), the vehicle
must be in ON/RUN mode and the
brake pedal must be applied.
Stopping the Engine/OFF (No Indicator
Light) : When the vehicle is stopped,
press ENGINE START/STOP once to
turn the engine off.
The transmission will shift to P (Park)
automatically.
If the vehicle is in P (Park), the
ignition will turn off, and Retained
Accessory Power (RAP) will remain
active. See Retained Accessory Power
(RAP) 0 195.
Warning
Turning off the vehicle while
moving may cause loss of power
assist in the brake and steering
systems and disable the airbags.
While driving, only shut the vehicle
off in an emergency.
If the vehicle must be shut off in an
emergency:
1. Brake using a firm and steady
pressure. Do not pump the brakes
repeatedly. This may deplete
power assist, requiring increased
brake pedal force.
2. Shift the vehicle to N (Neutral).
This can be done while the
vehicle is moving. After shifting
to N (Neutral), firmly apply the
brakes and steer the vehicle to a
safe location.
3. Come to a complete stop, shift to
P (Park), and press ENGINE
START/STOP. The transmission
must be in P (Park) to turn the
ignition switch to the OFF
position.
4. Set the parking brake. See Electric
Parking Brake 0 204.
If the vehicle cannot be pulled over
and must be shut off while driving,
press and hold ENGINE START/STOP
for longer than two seconds, or press
twice in five seconds.
DRIVING AND OPERATING
ACC/ACCESSORY (Amber Indicator
Light) : This mode allows you to use
some electrical accessories when the
engine is off.
With the ignition off, pressing
ENGINE START/STOP once without
the brake pedal applied will place the
ignition system in ACC/ACCESSORY.
The ignition will switch from ACC/
ACCESSORY to OFF after 10 minutes
to prevent battery rundown.
ON/RUN/START (Green Indicator
Light) : This mode is for driving and
starting. With the ignition off and the
brake pedal applied, pressing ENGINE
START/STOP once will place the
ignition system in ON/RUN/START.
Once engine cranking begins, release
the button. Engine cranking will
continue until the engine starts. See
Starting the Engine 0 192. The ignition
will then remain in ON/RUN.
Service Only Mode
This power mode is available to verify
the proper operation of the
malfunction indicator lamp as may be
required for emissions inspection
purposes, for service and diagnostics,
191