Hazard Warning Flashers; Turn And Lane-Change; Signals - Cadillac XT5 2017 Owner's Manual

the garage, there is a slight delay
before the automatic headlamp system
changes to the Daytime Running
Lamps (DRL). During that delay, the
instrument cluster may not be as
bright as usual. Make sure the
instrument panel brightness control is
in the full bright position. See
Instrument Panel Illumination
Control 0 166.
When it is bright enough outside, the
headlamps will turn off or may change
to DRL.
The automatic headlamp system turns
off when the exterior lamp control is
turned to or the ignition is off.
For vehicles sold in Canada, this
control only works when the
transmission is in P (Park).
Lights On with Wipers
If the windshield wipers are activated
in daylight with the engine on, and the
exterior lamp control is in AUTO, the
headlamps, parking lamps, and other
exterior lamps come on. The transition
time for the lamps coming on varies
based on wiper speed. When the
wipers are not operating, these lamps
turn off. Move the exterior lamp
control to or to disable this
feature.
HAZARD WARNING
FLASHERS
: Touch on the center stack to
make the front and rear turn signal
lamps flash on and off. Touch again to
turn the flashers off.
The hazard warning flashers turn on
automatically if the airbags deploy.
LIGHTING

TURN AND LANE-CHANGE

SIGNALS

Move the lever all the way up or down
to signal a turn.
An arrow on the instrument cluster
flashes in the direction of the turn or
lane change.
Raise or lower the lever until the arrow
starts to flash to signal a lane change.
Hold it there until the lane change is
completed. If the lever is briefly
pressed and released, the turn signal
flashes three times.
The turn and lane-change signal can
be turned off manually by moving the
lever back to its original position.
165