Cable Assembly - NordicTrack GRT500 User Manual

Cable Assembly

7. Open the parts bags labeled ÒCABLE ASSEMBLYÓ
and Ò4 PULLEYSÓ. Refer to the Cable Diagram on
page 16 as you assemble the cables.
Identify the High Cable (73), which has a ball on one
end and a bolt on the other end.
Locate the end of the High Cable (73) with the bolt.
Feed this end up through the indicated slot in the
Main Upright (3). Feed almost all of the Cable
through the slot.
Slide a 3/8Ó Flat Washer (55) and a 5/8Ó x 1/2Ó Pulley
Bushing (42) onto a 3/8Ó x 2 1/2Ó Bolt (54).
Wrap the High Cable (73) around a 4Ó Pulley (35).
Hold the Pulley inside the indicated slot in the Main
Upright (3). Insert the 3/8Ó x 2 1/2Ó Bolt (54) through
the Main Upright and the Pulley.
Slide a 5/8Ó x 1/2Ó Pulley Bushing (42) and a 3/8Ó Flat
Washer (55) onto the 3/8Ó x 2 1/2Ó Bolt (54). Tighten a
3/8Ó Nylon Jamnut (63) onto the Bolt.
8. Remove the upper 3/8Ó x 3Ó Bolt (45) from the Top
Frame (1) and the Main Upright (3).
Feed the bolt on the High Cable (73) down through
the indicated slot in the Main Upright (3) in the direc-
tion shown.
Wrap the High Cable (73) around a 4Ó Pulley (35) in
the direction shown. Attach the Pulley inside the slot
in the Main Upright (3) with a 3/8Ó x 2 1/2Ó Bolt (54),
two 3/8Ó Flat Washers (55), two 5/8Ó x 1/2Ó Pulley
Bushings (42), and a 3/8Ó Nylon Jamnut (63).
Re-insert the 3/8Ó x 3Ó Bolt (45) and secure it with a
3/8Ó Nylon Locknut (50). Note: The Cable must be
seated in the groove of the Pulley before the Bolt
is attached.
7
Bolt
55
63
42
8
35
Slot
50
1
42
63
55
Bolt
3
8
Slot
73
35
55
42
Ball
3
45
55 54
42
73
54