NordicTrack ASR 630 831.23765.0 User Manual page 11

12. Apply a generous amount of grease to the
axle on the Right Upper Body Leg (72). Then,
apply grease to a Large Wave Washer (89).
Slide an Upper Body Leg Spacer (9) and a
Large Wave Washer (89) onto the Right Upper
Body Leg (72). Make sure that the flat side of
the Upper Body Leg Spacer is facing out-
ward.
At the same time, slide the right Pedal Arm (32)
onto the Right Upper Body Leg (72) and insert
the right Link Arm (30) into the right Link Arm
Bracket (45).
Apply a small amount of grease to an M10 x
58mm Shoulder Bolt (104) and to the right Link
Arm Bracket (45). Attach the Link Arm (30) to
the Link Arm Bracket with the Shoulder Bolt, an
M8 x 23mm Washer (31) and an M8 Nylon
Locknut (94).
Then, attach the Pedal Arm (32) to the Right
Upper Body Leg (72) with an M8 x 23mm
Shoulder Screw (105), an M8 Washer (106), an
Axle Cover (66), and an M8 x 23mm Thin
Washer (96).
Repeat this step for the left Pedal Arm (32)
and the left Link Arm (not shown).
See step 4. Tighten the M8 x 19mm Patch
Screws (86).
13. Tighten an Adjustment Knob (52) onto an
Adjustment Pin (101).
Repeat this step for the other Adjustment
Knob (not shown) and the other Adjustment
Pin (not shown).
14. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the ellip-
tical exerciser.
12
32
104
45
13
11
72
Grease
9
89
Grease
96
106
105
32
66
Grease
31
30
94
52
101