NordicTrack 831.159760 User Manual page 20

45. Attach the upper end of the Shroud (56) to the two
"L"-brackets on the Top Frame (1) with two 1/4" x 3/4"
Bolts (17), two 1/4" Flat Washers (71), and two 1/4"
Nylon Locknuts (25). Make sure that the indicated
corner of the Shroud is lined up with the indicated
corner of the Top Frame. The Bolts must be
inserted through the square holes in the Shroud.
Do not tighten the Bolts yet.
46. Attach the lower end of the Shroud (56) to the bracket
on the Stabilizer (5) with four #8 x 3/4" Screws (32).
The Screws must be inserted through the square
holes in the Shroud and into the Tinnerman Clips (38).
Tighten the bolts used in step 45.
47. Insert a 1" Round Inner Cap (103) into each end of
the Lat Bar (61).
48. Attach the Curl Pad (21) to the Curl Post (83) with
four 1/4" x 3/4" Bolts (17).
49. Make sure that all parts have been properly tight-
ened. The use of the remaining parts will be
explained in ADJUSTMENT, beginning on page 22 of
this manual.
Before using the weight system, pull each cable a few
times to make sure that the cables move smoothly
over the pulleys. If one of the cables does not move
smoothly, find and correct the problem.
IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. If
there is any slack in the cables, you will need to remove the slack by tightening the cables. See TROU-
BLE-SHOOTING AND MAINTENANCE on page 24.
45
"L"-Brackets
Align
Corners
17
46
38
5
Bracket
47
103
48
17
20
1
71
71
25
56
38
32
56
32
61
103
21
83
17
32