NordicTrack 831.159760 User Manual page 16

32. Attach a 4" Pulley (35) inside the slot in the Leg Lever
(29) with a 3/8" x 2 1/2" Bolt (54), two 3/8" Flat
Washers (55), two 5/8" x 1/2" Pulley Bushings (42),
and a 3/8" Nylon Jamnut (63).
Attach the 1/2" x 1 3/4" Bushing (94) inside the bot-
tom of the Leg Lever (29) with a 5/16" x 2 1/2" Bolt
(96), two 5/16" Flat Washers (80), and a 5/16" Nylon
Jamnut (79).
Refer to the inset drawing. Press the Tab (93) onto
the cage as shown. Secure the Tab with a 1/4" x 1"
Bolt (95), a Large Washer (104), and a 1/4" Nylon
Locknut (25). Make sure that the Low Cable (72) is
on top of the Tab and the 1/2" x 1 3/4" Bushing (94).
Press a 2" Square Inner Cap (33) into the bottom of
the Leg Lever (29). Note: It may be easier to attach
the 2" Square Inner Cap and the 1/2" x 1 3/4"
Bushing (94) if you pivot the Leg Lever upward.
33. Route the Low Cable (72) through the indicated slot
in the Main Upright (3) and the Base (8).
Wrap the Low Cable (72) around a 4" Pulley (35) in
the direction shown. Attach the Pulley inside the
bracket on the Main Upright (3) with a 3/8" x 2" Bolt
(62) and a 3/8" Nylon Locknut (50) as shown.
34. Wrap the Low Cable (72) over a 4" Pulley (35). Slide
the Pulley and a Cable Trap (44) between the two
Pulley Plates (31). Make sure the Cable is in the
groove of the Pulley and that the Cable Trap is
oriented so it will hold the Cable in place.
Attach the 4" Pulley (35) and the Cable Trap (44) to
the lowest holes in the Pulley Plates (31) with a 3/8" x
1 3/4" Bolt (60) and a 3/8" Nylon Jamnut (63).
35. Wrap the Low Cable (72) around a 4" Pulley (35).
Attach the Pulley to the front hole in the bracket on
the Main Upright (3) with a 3/8" x 2" Bolt (62) and a
3/8" Nylon Locknut (50).
32
80
42
55
63
79
33
33
50
34
31
Adjustment
Holes
60
72
35
72
16
29
54
Slot
55
42
35
Cage
96
72
94
93
35
62
3
72
Slot
Bracket
63
44
35
35
62
50
72
95
104
25
8
3