Selecting The Parameters To Edit In The Selected Parts (Ch): Rev; The Mode "All" In Edit Menu - GEM GM-X Owner's Manual

owners manual

SELECTING THE PARAMETERS TO EDIT IN THE SELECTED PARTS (CH): REV

SELECTING THE PARAMETERS TO EDIT IN THE SELECTED PARTS (CH): REV
Set the REVERB (REV) level in the selected PART.
Press the EDIT button to select the REV. The display
indicates the current default value (REV=080), in this
example.
Pressing the DATA
crease the REV send in the selected part. The display
shows you in realtime the value changing. The pa-
rameter range is from 0 to 127.
As already described in the previous page, the ALL
mode is a way offer by the gm-x system to speed up
the editing operation for some parameters.
In fact setting the ALL mode in PART (CH) edit and selecting one of the edit parameters (*), the value you
insert affects all the parts at the same time.
In ALL MODE sets the GENERAL volume of the instrument.
VOLUME
Set a programmable VELOCITY offset, in order to increase (or decrease) the velocity of incoming MIDI notes trans-
V E L O C I T Y
mitted by a MIDI controller. Value range: -64/00/+63. Value= 00 does not affects the original velocity values.
(PERF mode)
TRANSPOSE Sets the GLOBAL transpose of the module +/- 12 semitones. This value is added to the PART value. The total
transpose value is: +/- 36 semitones (+/- 24 semitones in PART, plus +/- 12 semitone in ALL mode).
TUNE Control the GLOBAL tune of the module, from A = 427 to A= 452 Hz.
Control the effect (EFX) general level.
EFX
REV Control the reverb (REV) general level.
(*) The SOUND selection is excluded from the ALL mode.
Selecting the ALL mode the TUNE becomes a GLOBAL parameter.
Editing this parameter the display indicates the detune values in steps
of HERTZ. Range: from A = 427 to A= 452 Hz., A=440 standard
default value.
The VELOCITY parameter allows you to set a programmable VELOCITY offset, in order to increase (or decrease) the
velocity of incoming MIDI notes transmitted by a MIDI controller. Value range: -64/00/+63. Value= 00 does not affects
the original velocity values.
Select the "ALL" mode as explained in the above chapter.
1 1
Press the PERF button on the panel to enter the PERFORMANCE mode.
2 2
Press repeatedly the EDIT button to select the
3 3
VELOCITY parameter. The display indicates the
current default value, in this example.
If you need it, You can set the VELOCITY value, by
4 4
pressing the DATA
you in realtime the value changing.
Value range: -64/00/+63
This parameter is GLOBAL, then its setting will affect ALL the 16 parts at the same time and its setting is automatically memorized also
turning off the instrument.
REMEMBER in GM2 mode any PARTS (CH) parameter edit is temporary, in fact the Standard MIDI fi les contains the proper set of parameter for
each tracks and they have priority over the edit you have made.
It can happen that some Standard MIDI fi les may not have a complete set of instructions for tracks parameters recalling. In this case the gm-x
will replace these missing data with the Standard instrument and Parameters default (see the Table).
The PARTS and GLOBAL (ALL mode) data editing such as SOUND, TUNE, TRANSPOSE, etc. will be lost switching off the instrument.The Factory
GM2 default will be automatically restored once the module will be started on again.
Page 8
buttons to increase or de-

THE MODE "ALL" IN EDIT MENU

THE MODE "ALL" IN EDIT MENU
NOTE #1
NOTE #2
buttons. The display show
NOTE #3
REV -
Tune -
(See the chapter on the next page)
Velocity -
gm-x
REV +
Tune +
Velocity +