Selecting The Parameters To Edit In The Selected Parts (Ch): Velocity; Selecting The Parameters To Edit In The Selected Parts (Ch): Transpose; Selecting The Parameters To Edit In The Selected Parts (Ch): Tune; Selecting The Parameters To Edit In The Selected Parts (Ch): Efx - GEM GM-X Owner's Manual

owners manual

SELECTING THE PARAMETERS TO EDIT IN THE SELECTED PARTS (CH): VELOCITY

SELECTING THE PARAMETERS TO EDIT IN THE SELECTED PARTS (CH): VELOCITY
It is not possible to access the VELOCITY parameter in GM2 mode. To edit this parameter please consult
the NOTE #2 on next page.
This parameter works in PERF MODE only, after the Mode ALL enabling.
This parameter is GLOBAL, then its setting will affect ALL the 16 parts at the same time.

SELECTING THE PARAMETERS TO EDIT IN THE SELECTED PARTS (CH): TRANSPOSE

SELECTING THE PARAMETERS TO EDIT IN THE SELECTED PARTS (CH): TRANSPOSE
TRANSPOSE allows to shift the PART (CH) pitch in a range of +/- 24 semitones.
Press the EDIT button to select TRANSPOSE. The
display indicates the current default value
(TRANSPOSE= 00), in this example.
Pressing the DATA
crease the PART transpose. The display show you in
realtime the value changing. Each single step (+/- 24)
correspond to a semitone.

SELECTING THE PARAMETERS TO EDIT IN THE SELECTED PARTS (CH): TUNE

SELECTING THE PARAMETERS TO EDIT IN THE SELECTED PARTS (CH): TUNE
TUNE allows you to shift the PART (CH) pitch fi ne tuning in a range of : -64/00/+63
Press the EDIT button to select TUNE. The display
indicates the current default value (TUNE= 00), in
this example.
Pressing the DATA
crease the PART TUNE. The display show you in
realtime the value changing.

SELECTING THE PARAMETERS TO EDIT IN THE SELECTED PARTS (CH): EFX

SELECTING THE PARAMETERS TO EDIT IN THE SELECTED PARTS (CH): EFX
Set the EFX send level (chorus, tremolo, phaser, delay etc.) in the selected PART.
Press the EDIT button to select the EFX. The display
indicates the current default value (EFX=000), in this
example.
Pressing the DATA
crease the EFX send in the selected part. The display
shows you in realtime the value changing. The pa-
rameter range is from 0 to 127.
It is possible to restore the TRANSPOSE, TUNE and VELOCITY default value , by pressing the two DATA buttons at the same time.
buttons to increase or de-
buttons to increase or de-
buttons to increase or de-
Transpose -
Tune -
EFX -
NOTE
gm-x
Transpose +
Tune +
EFX +
Page 7