Selecting The Parts (Ch) In Gm2 Mode; Selecting The Parameters To Edit In The Selected Parts (Ch): Sound; Selecting The Parameters To Edit In The Selected Parts (Ch): Volume - GEM GM-X Owner's Manual

Hide thumbs

Table Of Contents

Table of Contents

owners manual

It is possible to select 16 different parts, corresponding

to the 16 standard MIDI channel.

Press repeatedly the DATA

show the PART (CH) number you wish to edit

Once all the 16 MIDI channel have been selected, the

display will show the message "ALL". This condition allows

you to modify some parameters values at the same time,

speeding up the editing operation. See on Page N.8, for

further details.

SELECTING THE PARAMETERS TO EDIT IN THE SELECTED PARTS (CH): SOUND

Once you have selected the PART you wish to modify

(#01 in this example), the EDIT menu parameter are

selected by pressing the EDIT button. Each time you

press the button a different parameter is selected.

The current default value of the selected parameter, is shown in the

display. In the part # the sound is: GRAND PIANO, the DOT closest

to the ﬁ rst digit indicates the sound BANK (#01). Please refer to the

included sound list at the end of the manual.

Pressing the DATA

button you select the next sound

in the sound database.

In order to ease and speed up the sound selection, the sounds

are mapped according to GM mapping. For each sound it's

possible immediately to select its VARIATION, (an alterna-

tive sound belonging to the same timbrel family, located in

a subsequent bank.)

Each time you press the DATA

is selected.

The second or third dot lighting on in the display,

indicates the selection of a sound variation located

in a subsequent sound bank.

The GM-X has 4 sound banks in total. From bank 0 (no dot light up

in the display), to bank 3 (three dot ligh up in the display).

SELECTING THE PARAMETERS TO EDIT IN THE SELECTED PARTS (CH): VOLUME

To select the VOLUME parameters of the selected PART

(CH) sound, press the EDIT button once more time. The

current default value of the parameter is indicated in

the display. Volume = 100 in this example.

You can increase or decrease the volume level, by

pressing the DATA

you in realtime the value changing.

Once you have reached the VOLUME = 000, (minimum sound

level), by pressing once more again the DATA

the selected part OFF, then the part is disabled.

Page 6