Gps Settings For Phoenix; Gps Control - Nokia RM-506 Service Manual

GPS settings for Phoenix

GPS control

Context
Use the following to test GPS using Phoenix.
Steps
1. Start Phoenix service software.
2. From the File menu, select Scan Product and check that the correct product version is displayed.
3. From the Testing menu, select GPS Control. This opens up
figure below, and enables the GPS.
Select Idle to confirm the GPS is enabled and is in idle mode; at this point all clocks should be present,
GPS_En_Reset should be high (1.8V), and Vdd_Dig (1.1V), Vcc_TCXO (2.5V) & Vcc_PLL/VCO (1.35V) should be
present. Turning Receiver Action
on.
Note: These checks are part of
Page 3 –44
Figure 26 GPS test pads
On will turn on all the RF sections of the ASIC and so all LDOs will be
GPS basic checks troubleshooting (page 3–50)
COMPANY CONFIDENTIAL
Copyright © 2009 Nokia. All rights reserved.
BB Troubleshooting and Manual Tuning Guide
GPS Control dialogue box, as shown in the
RM-505; RM-506
Issue 1