Setting The Flash Time; Setting The Area Code; Registration; Registering A Handset - Motorola K701 User Manual

3. Press SELECT and then VOL+ or REDIAL/VOL- to select
4. Press SELECT to save.
NOTE
If pulse mode is selected, press TONE/* to switch from pulse to tone dialing temporarily
when dialing out. After the call is ended, the dial mode will change back to pulse.
3.15.2

Setting the flash time

The default flash time is 600MS. It is unlikely that you should need to change this setting
unless advised to do so.
1. Press MENU and then VOL+ or REDIAL/VOL- to select
2. Press SELECT and then VOL+ or REDIAL/VOL- to select
3. Press SELECT and then VOL+ or REDIAL/VOL- to the flash time you want. (8 options
are available: 90, 100, 110, 250, 300, 400, 600 and 700MS)
4. Press SELECT to save.
3.15.3

Setting the area code

1. Press MENU and then VOL+ or REDIAL/VOL- to select
2. Press SELECT and then VOL+ or REDIAL/VOL- to select
3. Press SELECT and then enter the area code.
4. Press SELECT to save.
3.16

Registration

3.16.1

Registering a handset

Up to 5 handsets can be registered to one base. The original handset is pre-registered to
use. Additional handsets must be registered to the base before you can use them.
To register an additional handset,
1. Press MENU and then VOL+ or REDIAL/VOL- to select
2. Press SELECT and then VOL+ or REDIAL/VOL- to select REGISTRATION.
3. Press SELECT and then VOL+ or REDIAL/VOL- to select
4. Select YES then press SELECT to enter the registration procedure as follows:
1. Press and hold FIND for about 4 seconds on the base.
2. Place the unregistered cordless handset on the base or charger.
3. A confirmation tone is generated if registration is successful.
where X denotes the number of handsets, and then the phone returns to idle.
To register an originally unregistered handset, follow steps 1 through 3 above.
Using the phone
TONE or PULSE.
SETUP BS.
FLASH TIME.
SETUP BS.
AREA CODE.
SETUP HS.
YES or NO.
HANDSET X is displayed
27