Three-Party Conference Call; Setting The Dial Mode; Setting The Flash Time - Motorola P1001 User Manual

3.14.3 Three-party conference call

1. During an external call, press INT.
- Your caller is put on hold.
2. Press VOL+ or REDIAL/VOL- to select the handset you want to call.
3. Press MENU to call the handset.
4. When the other handset answers the intercom call, press MENU on the
calling handset to set up the conference call.
5. Press /BACK on any handset to end a three-party conference call and
leave the other handset engaged with the caller.
NOTE
During an external call, pressing
will join in the call and set up a conference call.

3.15 Setting the dial mode

The default dialing mode is suitable for your country and network operator. It is
unlikely that you should need to change this setting unless advised to do so.
1. Press MENU and then VOL+ or REDIAL/VOL- to select
2. Press MENU to select
3. Press MENU and then VOL+ or REDIAL/VOL- to select
4. Press MENU to save.
NOTE
If the pulse mode is selected, press TONE/* to switch from pulse to tone dialing
temporarily when dialing out. After the call is ended, the dial mode will change
back to pulse.

3.16 Setting the flash time

The default flash time is 600MS. It is unlikely that you should need to change this
setting unless advised to do so.
1. Press MENU and then VOL+ or REDIAL/VOL- to select
2. Press MENU and then VOL+ or REDIAL/VOL- to select
3. Press MENU and then VOL+ or REDIAL/VOL- to the flash time you want.
(8 options are available : 90, 100, 110, 250, 300, 400,
4. Press MENU to save.
Using the Phone
/FLASH or
DIAL MODE.
/SPEAKER on any handset
SETUP BS.
TONE or PULSE.
SETUP BS.
FLASH TIME.
600 and 700MS)
21