NOTE:
Steps 1 and 2 apply to computer models equipped with a graphics subsystem with discrete memory.
See steps 3 and 4 for heat sink removal instructions for computer models equipped with a graphics
subsystem with UMA memory.
1.
Remove the six Phillips PM2.0×6.2 screws (1) that secure the heat sink to the system board.
2.
Remove the heat sink (2).
NOTE:
memory. See steps 1 and 2 for heat sink removal instructions for computer models equipped with
a graphics subsystem with discrete memory.
3.
Remove the four Phillips PM2.0×6.2 screws (1) that secure the heat sink to the system board.
48
Chapter 5 Removal and replacement procedures
Steps 3 and 4 apply to computer models equipped with a graphics subsystem with UMA