Bosch Evolution 300 Series Service Manual page 24

Surface Igniter Spark Module
Photo E
To access the surface burner igniter spark module remove the surface
burners and cooktop as described in the previous sections. The spark
module is mounted onto a bracket located on the left side near the left
rear burner as seen in photo E
To access the module remove the two screws that fasten the bracket
Photo F
to the left hand body side then roll the bracket and spark module over
(Shoto F).
The spark module can also be accessed without removing the bracket
by depressing the locking tabs that hold it onto the bracket.
When reinstalling the module FRQILUP that the red wire is connected
to terminal L and the white/neutral wire is connected to terminal N on the
module. The green wire should be attached to the terminal nearest the
red wire. In some models the green wire may not be present.
2:11