Pulley Guard - BOMBARDIER Skandic 377 IR Shop Manual

(
DISASSEMBLY & ASSEMBLY
O
NOTE: For additional information (ex .: exploded
view) refer to the 1984 correspondent parts cata-
log .
•
WARNING: Engine should be running only when
belt guard and/or pulley guard are well secured
in place.
INSPECTION
Elan & Alpine models
Check the spring loaded retaining pin for free operation .
Replace any damaged parts.
Prior to installation, ensure that pulley guard and frame
bracket are 90
0
with frame .
No free-play
____ _ _ _ _ __ cm _ _
•
WARNING: No lateral free-play should exist be-
tween drive pulley guard and frame bracket.
ADJUSTMENT
Elan, Citation, Skandic & Alpine models
The length of the uncompressed retaining pin spring
should not be less than 47 mm (1
7/8").
An uncompressed front guard spring should not be less
than 20 mm
(13 /16").
When assembling adjust length
as illustrated below.
---::;::1
r-
0-3 threads
SECTION 03 TRANSMISSION
SUB-SECTION 01 (PULLEY GUARD)
PULLEY GUARD
Citation & Skandic models
When replacing the belt guard and brake support bracket,
the support bracket must be leveled to ensure full con-
tact of brake pad on disk. Use shim as illustrated below.
PAGE 185