Solving Network Problems; Solving Problems With The Remote Control - Epson PowerLite Pro G5900 User Manual

Solving Problems
108

Solving Network Problems

The projector does not send e-mail alerts even though the
e-mail notification function has been turned on.
Make sure the mail notification function is set correctly in the
■
configuration menu. See page 57.
Set Standby Mode to
■
menu. Otherwise, the projector cannot send e-mails when it is in
Standby mode (when the power is off).
■ If a critical problem develops with a projector which causes it to
suddenly stop working, it may not be possible for the projector to
send a message.
Make sure the projector is plugged in.
■
Make sure the LAN cable is connected correctly. Reconnect it if it
■
is not connected or it is not connected correctly (see page 54).
For problems with EasyMP Monitor, see the EasyMP Monitor
Operation Guide.
Solving Problems With the Remote
Control
The projector doesn't respond to remote control commands.
Point the remote control towards the receiver.
■
Make sure the projector and remote control IDs match. To
■
operate all projectors by remote control regardless of ID settings,
set the ID switch on the side of the remote control to
The remote control's batteries may not be installed correctly or
■
may be low on power. To change the batteries, see page 93.
in the Extended
Communication On
.
Off