Brother DCP-1608 User Manual page 27

2.Fax (For MFC-1906 and MFC-1908) (continued)
Level 2 Level 3
1.Setup 5.Memory
Receive Receive
(In FAX mode
only)
(Continued)
6.Print
Density
2.Setup Send 1.Contrast
The factory settings are shown in Bold with an asterisk.
Descriptions 1 Options
Automatically stores
On*
any incoming faxes in
its memory if it runs
out of paper.
The machine will
carry on receiving the
current fax, with the
remaining pages
being stored in
memory, if enough
memory is available.
Off
You can adjust the
-nnnno+
Print Density setting
-nnnon+
to make your printed
pages darker or
-nnonn+*
lighter.
-nonnn+
-onnnn+
Changes the
Auto*
lightness or darkness
of faxes you send.
Light
Dark
General information
Descriptions 2 Page
Further incoming
faxes will also be
stored into memory
until the memory is
full. When the
memory is full the
machine will stop
automatically
answering calls. To
print the faxes, put
fresh paper in the tray
and press Start.
Further incoming
faxes will not be
stored in memory.
The machine will
then stop
automatically
answering calls until
fresh paper is put in
the paper tray. To
print the last fax you
received, put fresh
paper in the tray and
press Start.
Press c to make
darker, press d to
make lighter.
Auto will give the
best results. It
automatically
chooses a suitable
contrast for your
document.
If your document is
too light, choose
Light.
If your document is
too dark, choose
Dark.
1
19