Ring Count; Caller's Recording Time; Message Alert - Panasonic kx-tg5438c Operating Instructions Manual

TG5438C_5439C(e-e).book Page 51 Saturday, November 6, 2004 11:17 AM

Ring count

You can change the number of times the
phone rings before the unit answers calls.
You can select "2", "3", "4" (default), "5",
"6", "7", or "Toll saver".
"Toll saver": The unit answers on the
2nd ring when new messages have been
recorded, and on the 4th ring when there
are no new messages. If you call your
phone from outside to listen to new
messages (page 49), you will know that
there are no messages when the phone
rings for the 3rd time. You can then hang
up without being charged for the call.
1
Press {MENU}.
2
Scroll to "Initial setting" by
pressing {V} or {^}, then press {>}.
3
Scroll to "Set answering" by pressing
{V} or {^}, then press {>}.
4
Scroll to "Ring count" by pressing {V}
or {^}, then press {>}.
5
Press {V} or {^} repeatedly to select
the desired setting.
L You can also select the ring count by
pressing {0} ("Toll saver"), or {2}
to {7}.
6
Press {Save}, then press {OFF}.

Caller's recording time

You can change the maximum message
recording time allotted to each caller.
"1min", "2min", or "3min" (default): Caller
messages are limited to 1 minute to 3
minutes.
"Greeting only": The unit plays the
greeting message but does not record
caller messages.
1
Press {MENU}.
2
Scroll to "Initial setting" by
pressing {V} or {^}, then press {>}.
Answering System Features
3
Scroll to "Set answering" by pressing
{V} or {^}, then press {>}.
4
Scroll to "Recording time" by
pressing {V} or {^}, then press {>}.
5
Press {V} or {^} repeatedly to select
the desired setting.
L You can also select the recording
time by pressing {1} to {3}, or {0}
("Greeting only").
6
Press {Save}, then press {OFF}.
Note:
L If message memory becomes full, the
unit will automatically switch to the
"Greeting only" mode.

Message alert

You can select whether or not the
message indicator on the handset will
flash when new messages have been
recorded (page 46). The default setting is
OFF.
1
Press {MENU}.
2
Scroll to "Initial setting" by
pressing {V} or {^}, then press {>}.
3
Scroll to "Message alert" by pressing
{V} or {^}, then press {>}.
4
Press {V} or {^} repeatedly to select
"On" or "Off".
5
Press {Save}, then press {OFF}.
Note:
L The message indicator will not flash for
new messages while the handset is in
use.
L While message alert is on, battery
operating time will be shortened (page
12).
51