Epson Stylus CX7300 User Manual page 98

6. Clean the document table glass with a soft, lint-free cloth moistened with a little glass cleaner.
Caution:
Do not spray glass cleaner directly on the glass.
7. Clean the document cover with a soft, non-abrasive microfiber cloth.
8. Close the document cover and paper support, then clean the outer case with a soft cloth
dampened with mild detergent.
After reconnecting the Epson Stylus CX7300 Series cables and turning it back on, you can clean
the rollers inside the printer. Load several sheets of plain paper and press one of the
(Start) buttons. (Do not place an original on the document table.) This feeds paper through the
printer to clean the rollers. Repeat if necessary.
Transportation
If you need to ship your Epson Stylus CX7300 Series or transport it a long distance, prepare it for
transportation as follows:
1. Turn off the Epson Stylus CX7300 Series.
2. Unplug all the connected cables.
3. Remove all the paper.
4. Close the paper support and output tray.
5. Lift up the scanner and check that the ink cartridge holder is all the way to the right (the home
position). If necessary, turn on the Epson Stylus CX7300 Series, then turn it off again.
6. Fasten the ink cartridge holder to the case using tape. Leave the ink cartridges installed to
avoid damaging the printer.
7. Close the scanner.
8. Pack the Epson Stylus CX7300 Series in its original box or one of a similar size using
protective material to keep it from moving inside the box.
9. Keep the Epson Stylus CX7300 Series level during transportation to prevent damage.
10. After unpacking the Epson Stylus CX7300 Series, remove the tape securing the ink cartridge
holder.
If print quality has declined when you print again in a new location, clean and align the print head.
98
Iniciar