Configuring The Memory - HP ProLiant DL580 Setup And Installation Manual

Memory

Configuring the Memory

Configuring or upgrading the server memory system requires configuring both
hardware and software. To configure the memory:
1. Remove the memory board. Refer to "Removing a Memory Board" in this
chapter.
2. Install the required DIMMs based on the desired memory configuration. Be sure
to follow all DIMM installation requirements. Refer to "DIMM Installation
Requirements" specific to the desired memory configuration in this chapter.
3. Install required memory boards. Refer to "Installing a Memory Board" in this
chapter.
4. Configure the DIMMs:
a. Power on the server.
b. Press the F9 key to enter RBSU.
c. Select Advanced Options.
d. Change POST Speed Up to Disable.
e. Press any key to return to the RBSU main menu.
f.
Select System Options.
g. Select Advanced Memory Protection.
h. Select the desired memory mode.
i.
Press the Esc key twice to go back to the main RBSU menu.
j.
Press the F10 key to exit RBSU. The server reboots and tests all memory in
the system.
k. Once the memory has been tested, re-enable POST Speed Up for faster
system boot, if desired.
IMPORTANT: To reconfigure the memory mode after initial setup, you must reboot the
system and enter RBSU.
6-18 HP ProLiant DL580 Generation 2 Server Setup and Installation Guide