Setting Up The Network - Siemens gigaset se 105 Quick Installation Manual

Setting up the network

You have to set up the network so that the PC can work with the router. First configure
the TCP/IP settings of the PC you have connected to the router.
Depending on the operating system, proceed as follows:
Windows 95/98/ME
1. Select Start - Settings - Control panel.
2. Double-click on the Network icon.
3. In the Network window, select the TCP/IP entry for your network card or adapter in
the Configuration tab. Make sure you select the correct TCP/IP entry if several are
offered in the list (e. g. "TCP/IP -> Siemens Gigaset USB Adapter 11" or
"TCP/IP -> Siemens Gigaset PC Card 11").
4. Click on Properties.
5. Click on the IP address tab and click on Automatically obtain IP address.
6. Click on the Gateway tab and remove any entries in the Installed Gateways list.
7. Click on OK twice to close the Network window.
8. Restart the network (see page 24).
Windows 2000
1. Click on Start - Settings - Control panel.
2. Double-click on the Network and dial-up connections icon and then on the LAN
connection icon.
3. In the General tab, click on the Properties button.
4. In the Properties of LAN connection window, select the TCP/IP entry for your
network card or adapter. Make sure you select the correct TCP/IP entry if several are
offered in the list (e. g. "TCP/IP -> Siemens Gigaset USB Adapter 11" or
"TCP/IP -> Siemens Gigaset PC Card 11").
5. Click on the Properties button.
6. Activate the options Automatically obtain IP address and Automatically obtain
DNS server address in the General tab.
7. Click on OK or Close to close each window.
8. Restart the network (see page 24).
Quick Installation Guide
23