Rs-232C Connector; Dc Out (Trigger Out) Jacks - Marantz SR6005 User Manual

RS-232C connector

When you connect an external control device, you can control the unit with the external control device.
Perform the operation below beforehand.
External serial controller
Perform the operation below beforehand.
q Turn on the power of this unit.
w Turn off the power of this unit from the external controller.
e Check that the unit is in the standby mode.
SVENSKA NEDERLANDS ESPAÑOL

DC OUT (TRIGGER OUT) jacks

When a device with DC IN jack is connected, the connected device's power on/standby can be controlled
through linked operation to this unit.
The DC OUT jack outputs a maximum 12 V/150 mA electrical signal.
Set to change the conditions for linked operation via the DC OUT (TRIGGER OUT) jack.
"Trigger Out" (vpage 67)
NOTE
If the permissible trigger input level for the connected device is larger than 12V/150 mA, or has shorted,
the DC OUT (TRIGGER OUT) jack cannot be used.
In this case, turn off the power to the unit, and disconnect it.
ITALIANO FRANÇAIS
12 V/150 mA trigger-compatible device
in Set as Necessary
DEUTSCH ENGLISH
41