Kohler 40COZ/33CFOZ Service Manual page 104

5. Attach the hoist hooks to the end bracket and
suspend the stator. Place the generator set
adapter on the floor and lower the stator to within
12.7--6.4 mm (0.05--0.25 in.) of the adapter lip. See
Figure 8-11.
Figure 8-11 Aligning Adapter and Stator
6. Align the adapter with the stator and start the bolts
with washers. Lower the stator onto the adapter
and finish tightening the bolts.
Note: Position the adapter hoisting eye so that it is
opposite the stator mounting bracket and
directly below the end bracket hoisting eye.
7. Place the generator set assembly on the end
bracket end when installing the rotor. Fasten the
hoisting hook to the end bracket eye and lower the
generator set assembly to a horizontal position.
8. Attach the hoisting hooks to the adapter as shown
in Figure 8-12. Suspend the generator set
assembly. Before lowering the generator set, place
boards along the edge of the end bracket. Maintain
a 25 mm (1 in.) clearance underneath the center of
the end bracket to prevent damage to the photo
transistor board and actuator cup when installing
the rotor.
9. Fasten the lifting eye and hoist hook to the rotor
flange. See Figure 8-13. Hoist the rotor to a vertical
position taking care not to damage the windings,
laminations, or bearing.
90
Section 8 Disassembly/Reassembly
Figure 8-12 Supporting Generator Set Assembly
3-083
R8348-7
1. Hoist hook
Figure 8-13 Hoisting Rotor
1
3-087
R8348-14
3-088
R8348-15
TP-5737 5/01