Weider 8507 User Manual page 8

11. Press a 1 3/4" Square Inner Cap (44) into each end
of an Arm (46).
Apply lubricant to the lower axles on the Arm Frame
(52). Slide an Arm (46) onto one of the axles. Hold
two 1" Retainers (54) and a 1" Round Cover Cap
(55) against the lower end of the axle. The teeth
on the Retainers must bend toward the Round
Cover Cap (see the inset drawing). Tap the
Retainers and Round Cover Cap onto the axle.
Assemble the other Arm (46) to the Arm Frame (52)
in the same manner.
12. Insert the two 4 1/2" "L" Pins (60) down through the
indicated holes in the Arm Frame (52) and the Arms
(46).
13. Wet both Arms (46) with soapy water. Slide a 7 3/4"
Pad (45) onto each Arm.
Slide a Handgrip (12) into the indicated end of a 7"
Handle (47). Insert the Handle into one of the Arms
(46). Attach the Handle with a 5/16" x 2.1/4" Bolt
(33), two 5/16" Flat Washers (8), a 1/2" x 3/8"
Spacer (51), and a 5/16" Nylon Locknut (3).
Attach a 7" Handle (47) to the other Arm (46) in the
same manner.
11
52
Lubricate Axle
Bracket
44
54
55
44
46
54
12
60
52
46
13
46
47
3
46
8
8
49
45 51
33
45
47
8
ATTACHING AND REMOVING THE SEAT
Set the bracket on the Seat Frame (36) on the indicated
pin on the Front Upright (42). Attach the Seat Frame to
the Front Upright with the 5/16" x 2 3/4" Carriage Bolt
(14) and Seat Knob (40).
For some exercises, the Seat (13) must be removed.
First, make sure that the chain is not attached to the leg
lever. Next, remove the Seat Knob (40) and 5/16" x
2.3/4" Carriage Bolt (14) from the Seat Frame (36). Lift
the Seat Frame off the Front Upright (42).
ATTACHING THE LEG LEVER TO THE LOW
PULLEY STATION
To use the Leg Lever (29), the seat must be attached to
the front upright (see ATTACHING AND REMOVING
THE SEAT on page 13). Attach the Chain (84) between
the Short Cable (23) and the 5/16" x 2" Eyebolt (35) on
the Leg Lever with two Cable Clips (83).
Axle
55
ATTACHING THE LAT BAR OR NYLON STRAP TO
THE HIGH PULLEY STATION
Attach the Lat Bar (85) to the Long Cable (66) with a
Cable Clip (83). For some exercises, the Chain (84)
should be attached between the Lat Bar and the Long
Cable with two Cable Clips. Adjust the length of the
Chain between the Lat Bar and the Long Cable so
the Lat Bar is in the correct starting position for the
exercise to be performed.
12
The Nylon Strap (39) can be attached in the same man-
ner.
36
40
14
Pin
42
84
83
23
62
83
66
84
85
39
17
29