Hardware Installation And Connection; Freestanding Installation - ZyXEL Communications GS1900 Series User Manual

Hardware Installation and Connection

This chapter shows you how to install and connect the Switch.

2.1 Freestanding Installation

Make sure the Switch is clean and dry.
1
Set the Switch on a smooth, level surface strong enough to support the weight of the Switch and
2
the connected cables. Make sure there is a power outlet nearby.
Make sure there is enough clearance around the Switch to allow air circulation and the attachment
3
of cables and the power cord.
Remove the adhesive backing from the rubber feet.
4
Attach the rubber feet to each corner on the bottom of the Switch. These rubber feet help protect
5
the Switch from shock or vibration and ensure space between devices when stacking.
Figure 4 Attaching Rubber Feet
Note: Do NOT block the ventilation holes. Leave space between devices when stacking.
Note: For proper ventilation, allow at least 4 inches (10 cm) of clearance at the front and
3.4 inches (8 cm) at the back of the Switch. This is especially important for
enclosed rack installations.
C
H A PT ER
GS1900 Series User's Guide
19
2