Cid 0005 Fmi 07; Cid 0006 Fmi 02 - Perkins M190C Troubleshooting Manual

82
Troubleshooting Section
Troubleshooting:
When an injector cutout test is performed, a faulty
electronic unit injector will indicate a low reading in
comparison with the other electronic unit injectors.
An electrical fault can prevent the electronic unit
injector from operating. A short circuit in the wiring or
the ECM that is unique to one electronic unit injector
will prevent that individual electronic unit injector from
operating. A short circuit in common wiring within the
ECM can prevent the three electronic unit injectors
that share that common wiring from operating.
The ECM will continue to attempt to operate the
electronic unit injector after the diagnostic code
has been logged but a short circuit will prevent the
operation of the electronic unit injector.
Perform the following diagnostic procedure: "Injector
Solenoid Circuit - Test"
Results:
•
OK – STOP.

CID 0005 FMI 07

Conditions Which Generate This Code:
This diagnostic code is applicable to six cylinder
engines only.
The electronic unit injector is no longer capable of
delivering the correct amount of fuel.
System Response:
If equipped, the warning light will come on. The
Electronic Control Module (ECM) will log the
diagnostic code.
Possible Performance Effect:
The engine will be derated.
Troubleshooting:
Use the electronic service tool to perform the
Verification Test on the fuel system. If the diagnostic
code is still active, do the following procedure.
Replace the suspect electronic unit injector. Refer
to Disassembly and Assembly, "Electronic Unit
Injector - Remove" and Disassembly and Assembly,
"Electronic Unit Injector - Install".
Use the electronic service tool to perform the
Verification Test on the fuel system.
Perform the following diagnostic procedure: "None"
Results:
•
OK – STOP.

CID 0006 FMI 02

Conditions Which Generate This Code:
This diagnostic code is applicable to six cylinder
engines only.
The Electronic Control Module (ECM) detects the
following condition:
• Data from the electronic unit injector for the No. 6
cylinder is out of limits.
• Diagnostic code 0168-01 is not active.
i03449942
• Diagnostic codes 0001-05 and 0001-06 are not
active.
• No 0041 diagnostic codes are active.
•
No 0262 diagnostic codes are active.
• Diagnostic code 0190-08 is not active.
• No 0110 diagnostic codes are active.
System Response:
If equipped, the warning light will come on. An active
diagnostic code will be generated. The ECM will log
the diagnostic code.
Possible Performance Effect:
The engine will be derated while this diagnostic code
is active.
Troubleshooting:
Perform the following diagnostic procedure: "Injector
Data Incorrect - Test"
Results:
•
OK – STOP.
KENR9126
i02655557