Cid 0005 Fmi 07 Cylinder #5 Injector Not Responding; Cid 0006 Fmi 02 Cylinder #6 Injector Data Incorrect; Cid 0006 Fmi 05 Cylinder #6 Injector Open Circuit - Perkins 1106D Troubleshooting Manual

SENR9982
CID 0005 FMI 07 Cylinder #5
Injector Not Responding
Conditions Which Generate This Code:
The electronic unit injector is no longer capable of
delivering the correct amount of fuel.
System Response:
If equipped, the warning light will come on. The
Electronic Control Module (ECM) will log the
diagnostic code.
Note: The diagnostic code can be viewed on the
electronic service tool.
Possible Performance Effect:
The engine will be derated.
Troubleshooting:
Replace the suspect electronic unit injector. Refer
to Disassembly and Assembly, "Electronic Unit
Injector - Remove" and Disassembly and Assembly,
"Electronic Unit Injector - Install".
Use the electronic service tool to perform the fuel
system verification test.
Perform the following diagnostic procedure: "None"
Results:
•
OK – STOP.
CID 0006 FMI 02 Cylinder #6
Injector Data Incorrect
Conditions Which Generate This Code:
The Electronic Control Module (ECM) detects the
following condition:
•
Data from the electronic unit injector for the No. 6
cylinder is out of limits.
•
Diagnostic code 0168-01 is not active.
•
Diagnostic codes 0001-05 and 0001-06 are not
active for the No. 6 cylinder.
•
No 0041 diagnostic codes are active.
•
No 0262 diagnostic codes are active.
i02412182
•
Diagnostic code 0190-08 is not active.
•
No 0110 diagnostic codes are active.
System Response:
If equipped, the warning light will come on. An active
diagnostic code will be generated. The ECM will log
the diagnostic code. The ECM will trigger a snapshot.
Possible Performance Effect:
The engine will be derated while this diagnostic code
is active.
Troubleshooting:
Perform the following diagnostic procedure: "Injector
Data Incorrect - Test"
Results:
•
OK – STOP.
CID 0006 FMI 05 Cylinder #6
Injector open circuit
Conditions Which Generate This Code:
This diagnostic code is designed to indicate an open
circuit (low current) in either the solenoid or the wiring
for the electronic unit injector for No. 6 cylinder.
The Electronic Control Module (ECM) detects the
following condition:
i02412183
•
A low current condition (open circuit) for each of
five consecutive attempts to operate
• Battery voltage is higher than 9 volts for 2 seconds.
System Response:
If equipped, the warning light will come on. The ECM
will log the diagnostic code.
Possible Performance Effect:
The engine will have low power and/or rough running.
Troubleshooting:
When an injector cutout test is performed, a faulty
electronic unit injector will indicate a low reading in
comparison with the other electronic unit injectors.
85
Troubleshooting Section
i02412184