Disassembly Procedure - Yamaha P-200 Service Manual

DISASSEMBLY PROCEDURE

1 Opening Control Panel Unit
Remove the four (4) screws marked [240]
located under the keybed. (Fig. 1)
* Lift the control panel unit from the front and
pass strings through two side plates and both
ends of the keybed, as shown in the figure so
that hinges are not damaged. (Fig. 2)
CAUTION:MAKE SURE THAT THE
UPPER CASE IS SECURE.
Bottom side
[ 240 ]
[ 240 ]: Pan Head Screw PW 5.0 x 25 MFZN2BL(VB919400)
(Fig. 1)
(Fig. 2)
Strings
Keybed
P-200
Control panel unit
5