Q-See QT SERIES User Manual page 19

Time Tab
You can set the length of time the DVRs record an event before and after a motion detection or alarm is
triggered as well as how long an individual record is preserved.
Pre-alarm record time: This sets the length of
time showing events prior to a motion
detection or sensor-triggered event that is
included in the record.
Post-alarm record: Sets the length of time - from
10 to 60 seconds - that is added to the
record after the event is finished.
Expire time: The time - up to 60 days - that an
event is saved on the drive before it could
be overwritten (See Recycle Record
below).
You can set up all channels with same values by selecting All and then configuring one channel.
Stamp Tab
Select which cameras will display their ID and date stamp and where it'll appear on the screen.
Drag and drop the location of the camera name
and date/time stamp to your desired location
on the screen. This can be done individually or
globally. A "Before" and "After" example is shown
below.
36
PICTURE 4-15
PICTURE 4-16
PICTURE 4-17
Snap Tab
In this tab, you can configure how many still images are taken, the quality of the images and the timing
between them when the Snapshot button is pushed on the Control Bar.
Recycle Record Tab
This is selected by default. Recycle record allows the DVR to record over old events when the hard drive
is full. Otherwise, the DVR will stop recording when there is no more space available.
RECORD RECORD
Enable Enable Record Bitrate Record Bitrate Time Time Stamp Stamp Recycle Record Recycle Record Snap Snap
Resolution Resolution CIF CIF
Quality Quality
Medium Medium
Snap Time Interval [S] Snap Time Interval [S] 2 2
Snap Number Snap Number
1 1
Default Default Apply Apply Exit Exit
PICTURE 4-18
37