Solid-State Drive (M.2) - HP ENVY PRO Maintenance & Service Manual

Solid-state drive (M.2)

Description
256-GB solid-state drive, 2280SS, PCIe
128-GB solid-state drive, 2280SS, PCIe
Before removing the solid-state drive, follow these steps:
To remove the solid-state drive:
1. Prepare the computer for disassembly (see
2. Remove the bezel (see
3. Remove the display panel (see
4. Remove the system board (see
Remove the solid-state drive:
1. Remove the Phillips PM2.0×3.5 screw (1) that secures the solid-state drive to the system board.
NOTE:
dictated by the spring mechanism.
When installing the module, be sure to insert the module at the angle that it sits after the screw is
removed and the module springs up.
2. Remove the solid-state drive (2) by pulling the drive away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
Bezel on page
Display panel on page
System board on page
If the module springs up when the screw is removed, be sure to remove the module at the angle
Preparing to disassemble the computer on page
23).
26).
43), and then turn it over.
17).
Solid-state drive (M.2) 51