Service Required Error Messages - Epson AcuLaser CX-11N Repair Manual

Epson AcuLaser CX-11N/AcuLaser CX-11NF Field Repair Guide

Service Required Error Messages

Class Panel Message
Service Req E510
Service Req E511
Service Req E513
Service Req E514
Service Req E517
Service Req E520
Service Req E521
Service Req E524
Service Req E525
Service Req E526
ROS Motor Failure
PWBA MCU could not receive signals output from SOS Sensor in ROS within the specified
time.
TR0 Failure
PWBA MCU could not receive signals output from SENSOR TR-0 (TR0 Sensor) at the
specified timing.
NVRAM Error
An error occurred in NVRAM on PWBA MCU.
PAGE Timeout
The PAGEC/PAGE signal was not received within 60sec after transmitting PFA.
Communication Error Feeder
A communication error occurred between PWBA MCU and Feeder.
BTR 2 Advance Error
The 2nd BTR Retract Sensor did not turn ON within the specified time.
BTR 2 Error
The input of 2nd BTR Retract Sensor did not change when 2nd BTR is initialized.
Low Density
The output value of SENSOR ASSY ADC (ADC Sensor) is below the specified value.
High Density
The output value of SENSOR ASSY ADC (ADC Sensor) exceeds the specified value.
ADC Sensor Contamination
SENSOR ASSY ADC (ADC Sensor) error
Printer Component, Software Item,
Description
LCD Display, Printer Button
manuals4you.com manuals4you.com
9/9/05
See FIP
40 (p.208)
39 (p.206)
38 (p.205)
37 (p.204)
36 (p.203)
47 (p.217)
46 (p.216)
44 (p.213)
43 (p.211)
42 (p.210)
Page 44.