Jensen CD3610XM Owner's Manual page 3

CD3610XM
Preparation (continued)
Install Half-Sleeve
1. Install adapter and dash kit if necessary (optional).
2. Install half-sleeve into adapter or dashboard.
3. Push tabs out to secure half-sleeve in the radio opening.
4. Install support strap to make unit more stable.
Wiring
Wiring with a Wiring Adapter (Purchased Separately)
Connect Wires
You can make all these connections without even being in the vehicle.
1. Splice or crimp wires.
2. Attach wiring adapter to the car wiring harness.
Wiring Diagram / Color Codes
1. Power Antenna (dark blue wire) - Connect to the power antenna or a amplifier. If not used,
tape the bare end of wire.
2. Ground (black wire) - Connect to the ground terminal or a clean, unpainted part of the
chassis.
3. Memory/Battery (yellow wire) - Connect to the battery or to a 12 volt power source that is
always alive. The radio will not work if this wire is not connected.
4. Accessory/Ignition (red wire) - Connect to the existing radio wire or radio fuse.
5. Left front speaker
6. Right front speaker
7. Left rear spearker
8. Right rear speaker
9. Rear RCA preamp out (gray RCA)
10. Auxiliary Input Cable (yellow)
11. Antenna
®
12. XM Direct Connect Cable
®
13. XM Audio Input (black RCA)
*Cables sold separately.
®
**XM Direct Tuner and antenna sold separately.
Install Half-Sleeve
Instalación de la Camisa
Installation du Demi-Manchon
3
2
Wiring
Cableado
Câblage
3
Connect Wires
Conecte los Cables
Raccordement des Fils
Jensen Connector
4
1
1
2