Table of Contents
Advertisement
First steps
Attaching the belt clip
The handset has notches on each side to attach the belt clip.
¤ To attach — press the belt clip onto
the back of the handset so that the
protrusions on the belt clip engage
with the notches.
¤ To remove — using your right
thumb apply pressure to the centre
of the belt clip, push the fingernail
of your left index finger between
the clip and the casing and lift the
clip upwards.
Initial charging and discharging of the batteries
The correct charge status can only be displayed if the batteries are first fully charged and
discharged.
¤ Charge the handset in the charging cradle for 10 hours.
Please note
The handset must only be placed in the designated Gigaset C610/C610A base or
charging cradle.
¤ After charging, remove the handset from the charging cradle and only replace it
when the batteries are fully discharged.
Please note
u After the initial battery charge and discharge, you may place your handset in the
base after every call.
u Always repeat the charging and discharging procedure if you remove the batter-
ies from the handset and reinsert them.
u The batteries may warm up during charging. This is not dangerous.
u After a while, the charge capacity of the batteries will decrease for technical rea-
sons.
10
10 h
Advertisement
Table of Contents
