Refitting The Rear Wheel; Swing-Arm - PIAGGIO 2005 XEVO 400ie Workshop Manual

Suspensions

Refitting the rear wheel

To fit, follow the removal steps but in the reverse
sequence, being careful to fit the spacers on the
wheel axle as shown in the picture.
Locking torques (N*m)
Muffler arm clamping screws
axle nut Shock absorber-crankcase at-
104 ÷ 126
tachment bracket
20 ÷ 25
clamping screw
33 ÷ 41 Nm
fixing screws
25 ÷ 30 Nm

Swing-arm

The scooter features a rigid engine-chassis retain-
er called Direct-link.
The system comprises the following components:
A= Left spacer
B= RHS engine support bearing
C= Central spacer
D= Right spacer
E= LHS engine support bearing
F = Chassis
Removal
- Support the engine adequately.
- Remove the pin anchoring the engine to the
chassis.
- Move the engine backwards to take out spacers
- Remove the left spacer highlighted in the figure.
SUSP - 278
Rear wheel
27 ÷ 30
Lower shock absorber
Rear brake calliper
XEVO 400ie