Lubrication; Technical Specifications; Recommended Engine Oil; Oil Pump - PIAGGIO 2005 XEVO 400ie Workshop Manual

Engine
- Check that the crankshaft rotates freely.
N.B.
REMOVE ANY EXCESS FROM THE CRANKCASE COUPLING GASKET ON THE CYLINDER
PLANE, TO ENSURE BETTER SEALING PERFORMANCE.
Locking torques (N*m)
Engine-crankcase coupling screws 11 ÷ 13
- Install the thermal group (cylinder, head, piston) as described in section «Thermal group and timing
system».
- Install the flywheel with start-up control as described in the "Flywheel and start-up" chapter.
- Install the flywheel cover with the cooling system sleeves, as described in the "Flywheel cover chapter".
- Install the complete driving pulley, the transmission cover and the relevant mesh filter and the outside
transmission cover as described in the «Automatic transmission» chapter.
See also
Flywheel cover
Cylinder assy. and timing system

Lubrication

TECHNICAL SPECIFICATIONS

Specification
Overhaul
Oil and filter replacement
Product
AGIP CITY HI TEC 4T
Specification
Rotor washers
Assembly clearances
External rotor radial clearance
Rotor axial clearance
Specification
Plunger diameter
Spring free length
Calibration pressure
Specification
ENG - 160
SUMP CAPACITY

RECOMMENDED ENGINE OIL

Description
Engine oil

OIL PUMP

Type
BY-PASS
Type
PRE-FILTER
Type
XEVO 400ie
Desc./Quantity
1.7 l
1.5 l
Specifications
SAE 5W-40, API SL, ACEA A3, JASO MA
Synthetic oil
Desc./Quantity
Trochoidal
8 mm
Lobe ends 0.05-0.008 mm
0.05- 0.12 mm
0.025 - 0.065 mm
Desc./Quantity
with piston
13.9 - 0.039 -0.057 mm
62.5 mm
4 bar
Desc./Quantity
mesh, plastic