Canon LBP7780CX User Manual page 919

Cannot perform 2-Sided Printing. <Auto Error Skip>
<Cause> The printer received 2-sided printing data of paper sizes (including the orientation) or paper
types unavailable for automatic 2-sided printing.
Press [
Solution 1
Perform the following procedure.
1. Perform a soft reset.
Solution 2
2. Change the setting to a paper size or type available for automatic 2-sided printing, and then print
again.
Cannot print with the specified resolution. <Auto Error Skip>
<Cause> The printer cannot process the data because it is too complicated.
Press [
Solution 1
being lowered.
Perform the following procedure.
1. Perform a soft reset.
Solution 2
2. Set [Gradation Level] to [High 1], and then print again.
Cannot print. Reg. Table is full. <Auto Error Skip>
<Cause> The total number of binders inside a single job exceeds 32, or the number of documents inside
a single binder exceeds 80.
Press [
Solution 1
Solution 2 Confirm the data to be printed, and then print again.
Cannot read PDF data.
<Cause> An error has occurred when the PDF data was read.
Perform the following procedure.
1. Perform a soft reset.
Solution
2. Print the PDF data in a format which this printer supports again.
Cannot receive PDF data. Set the receivable size. <Auto Error Skip>
<Cause> There is not sufficient free space to print the PDF file using the direct print function.
Press [
] ( : Online) to continue printing. However, the data on each side is printed on two pages.
"Canceling the Process Currently Being Performed (Soft Reset)"
] ( : Online) to continue printing. In this case, the printer prints with the image quality level
"Canceling the Process Currently Being Performed (Soft Reset)"
"[Setup] Menu ([Quality] Options)"
] ( : Online) to continue printing. However, the data may not be printed properly.
"Canceling the Process Currently Being Performed (Soft Reset)"
] ( : Online) to cancel the job. Afterward, perform the following processes (decreasing the