Levelling The Refrigerator - Samsung RL-55 series User Manual

3. Assemble the handles after switching the side of
the Fridge handle and the Freezer handle.
4. Tighten 2 screws underneath the Fridge door
and then assemble 2 screws and 2 Cap sheets
on the Freezer door.
REVERSING THE DOOR
HANDLE (TYPE B)
1. Remove 2 screws underneath the Fridge door
and then pull the Handle cover.
Screw Screw
Disassemble the Handle cover carefully.
Hooks inside of the Handle cover can break
WARNING
easily.
2. Remove 2 screws on the Handle grommets.
Remove the Handle grommets and disassemble
the Easy handle.
Screw Screw
Grommet Grommet
18_ setting up
DA99-02116A (EN)-12.indd 18 DA99-02116A (EN)-12.indd 18
3. Change the positions of the Handle slider and
spring from the left side to the right side.
Make sure to change position of the Handle
slider cap from the right side to the left side.
4. Assemble the door handle by following step 2
and 1 in reverse order.
LEVELLING THE
REFRIGERATOR
If the front of the appliance is slightly higher than
the rear, the door can be opened and closed more
easily.
Turn the adjusting legs clockwise to raise and
counter-clockwise to lower the height.
Case 1) The appliance tilts down to the left.
• Turn the left adjusting leg in the direction of the
arrow until the appliance is level.
Case 2) The appliance tilts down to the right.
Cover handle Cover handle
• Turn the right adjusting leg in the direction of the
arrow until the appliance is level.
handle handle
Slider Slider
Spring Spring
This procedure must be done before
'Reversing the Refrigerator Door' step 23.
Screw Screw
2014. 8. 14. 2014. 8. 14. 1:26 1:26