Troubleshooting - Nextar NCD60C Instruction Manual

TROUBLE SHOOTING
Before using this checklist, please make all the connections first. If you still
have questions after going through the checklist, please consult your local
customer service representative.
Common Symptoms
There is no power.
The CDs cannot
be loaded.
The CDs are loaded The transport screws have not been
only halfway into
the CD tray.
The device does
not work correctly.
(EJECT, LOAD,
PLAY)
There is no sound.
The operation keys
do not work.
The CD player
skips.
No radio reception.
In automatic search
Mode, the radio does
not stop at a trans-
mitting station.
Cause
The car ignition is switched off.
The fuse has blown.
Presence of CD inside the player.
removed.
The disc has been inserted upside
down.
The surface of the CD is extremely
dirty or damaged.
Temperature inside the car is too
high.
The volume control is set too low.
The device has not been correctly
connected.
1. The built-in microcomputer is not
operating properly due to noise.
2. The front panel is not properly
in place.
The installation angle is more than
30 degrees.
The surface of the road is uneven.
The surface of the CD is extremely
dirty or damaged.
The antenna cable is not connected.
The transmission signals are too
weak.
If the power supply is properly connected to
the car accessory, switch the ignition key to
"ON" or "ACC".
Replace with another fuse according to the
wiring diagram.
Remove the disc in the player, then put in a
new one.
Remove the transport screws before use.
Insert the compact disc with the label facing
upward.
Clean the CD or try another CD. If this works
correctly, the first CD is probably damaged.
Cool off until the ambient temperature returns
to normal.
Turn up the volume to an audible level.
Check the power and earth connection
according to the wiring diagram.
1. Switch the device off and on again. Or,
press the RESET button to resume the
program.
2. Reinstall
Adjust the installation angle to less than 30
degrees.
Wait until the road becomes smoother before
playing the CD.
Clean the CD or try another CD. If this works
correctly, the first CD is probably damaged.
Insert the antenna cable firmly into the
antenna socket of the device.
Tune in to a radio station manually.
Page 8
Solution
the front panel.