Location And Function Of Controls; Release Button; Dsp Settings - Nextar NCD60C Instruction Manual

LOCATION AND FUNCTION OF CONTROLS

1. RELEASE BUTTON

Press this button to eject the front control panel from the main body.
2, 3 & 4. SEL BUTTON (Select) AND VOLUME (MENU) UP (+) / DN (–) BUTTONS
a) Press the SEL button briefly to select each of the following modes:
VOLUME - > BASS - > TREBLE - > BALANCE - > FADER - >
When the desired audio mode is selected, press the + or – button to adjust the
value of that audio effect.
In each mode you have about 3 seconds to make your changes before the
display returns to the tuner (radio) or CDP mode.
The different audio modes display the following numeric ranges:
- VOL : (MIN) 0 , 0 1 , . . . ...49, 63 (MAX) .
- BASS / TREB: - 7 , - 6 , . . . , 0 , . . . + 6 , + 7
- BAL : 1 0 L , 9 L , . . . , 0 , . . . 9 R , 1 0 R
- FAD : 1 0 F, 9 F, . . . , 0 , . . . 9 R , 1 0 R
Note: If you preselect a preset EQ (Preset Equalizer Curves), you cannot
change the BASS and TREBLE values.
b) Press the SEL button and hold it for more than 2 seconds to access the menu
mode. Now press the SEL button briefly to select from the following options:
EQ (OFF / FLAT / CLASS / ROCK / POP ) - > BEEP ON / OFF - > SEEK 1 / 2 - >
12 H / 24 H - > VOL LAST / ADJ .

DSP SETTINGS:

In EQ mode you can select from the equalizer settings DSP OFF, FLAT, CLASS,
ROCK and POP by pressing the + and – buttons.
BEEP ON / OFF :
Turn the confirmation beep on or off by pressing the + or – button .
BEEP ON: The confirmation beep can be heard whenever a button is pressed.
BEEP OFF: The confirmation beep is switched off.
Page 2