Charmglow 720-0230 Use And Care Manual page 11

Side burner valve assembly:
Step 1: Insert valve assembly through side
panel
Step 3: Insert valve stem assembly into burner
venturi
Valve Stem
Valve
Step 5: Replace "U" brackets with 4(four)
Screws( DO NOT TIGHTEN)
#32
Step 7; Tight all 4(four) screws on the "U"
brackets on the burner, then connect
the ignition wire on to valve.
(Ignition wire)
ASSEMBLY INSTRUCTIONS
(Side panel, right #18B)
Valve
(Control Panel #32 )
#37
Step 2: Remove 4(four) screws & washers
from the "U" brackets on the side
burner
Step 4: Insert valve stem assembly through knob
hole to the control panel
Step 6: Align & tighten knob bezel & valve
stem with 2(two) screws & washers
as shown below.
(knob bezel in bag)
Step 8: Place knob on valve stem, then screw
the knob by using the Allen wrench.
(Allen wrench enclosed in bag )
9
#
37