DSC GSM 1000 Installation Manual page 23

LIMITED WARRANTY
Sur-Gard Security Systems Ltd. warrants that for a period of twelve months from the date of purchase, the
product shall be free from defects in materials and workmanship under normal use and that in fulfilment of
any breech of such warranty, Sur-Gard Security Systems Ltd. shall, at its option, repair or replace the
defective equipment upon return of the equipment to its repair depot. This warranty applies only to defects
in parts and workmanship and not to damage incurred in shipping or handling, or damage due to causes
beyond the control of Sur-Gard Security Systems Ltd., such as lightning, excessive voltage, mechanical
shock, water damage, or damage arising out of abuse, alteration or improper application of the equipment.
The foregoing warranty shall apply only to the original buyer, and is and shall be in lieu of any and all other
warranties, whether expressed or implied and of all other obligations or liabilities on the part of Sur-Gard
Security Systems Ltd. Sur-Gard Security Systems Ltd. neither assumes, nor authorizes any other person
purporting to act on its behalf to modify or to change this warranty, nor to assume for it any other warranty
or liability concerning this product.
In no event shall Sur-Gard Security Systems Ltd. be liable for any direct or indirect or consequential
damages, loss of anticipated profits, loss of time or any other losses incurred by the buyer in connection
with the purchase, installation or operation or failure of this product.
WARNING: Sur-Gard Security Systems Ltd. recommends that the entire system be completely tested on
a regular basis. However, despite frequent testing, and due to but not limited to, criminal tampering or
electrical disruption, it is possible for this product to fail to perform as expected.
CE CONFORMITY
The GSM 1000 module will bear the CE symbol of conformity. This symbol is a declaration that on account
of its design and implementation, the GSM 1000 is in compliance with the currently valid versions of the
following EC Directives.
89/336/EC
73/23/EC
91/263/EC
CTR21 Notes
1. This equipment has been approved in accordance with Council Decision 98/482/EC for pan-European
single terminal connection to the public switched telephone network (PSTN). However due to differences
between the individual PSTNs provided in different countries, the approval does not, of itself, give an
unconditional assurance of successful operation on every PSTN network termination point.
In the event of problems, you should contact your equipment supplier in the first instance.
2. This equipment was designed to work on the PSTN networks in the following countries: Austria, Belgium,
Denmark, France, Germany, Greece, Iceland, Ireland, Italy, Israel, Norway, Portugal, Spain, Sweden,
Switzerland, Netherlands and the UK.
If there is special Software programming to be done for a specific country this will be noted in the
Programming Worksheets booklet. Therefore, please consult the Worksheets booklet during programming
of the equipment and take note of any special country specific requirements for the PSTN.
If this equipment is to be connected to a PSTN in a country that is not listed above, please contact the
vendor to check for compatibility with the network in question.
3. This equipment has only been approved for and is only intended for use with DTMF dialing.
4. In order to comply with CTR21 regulations, the Maximum Number of Dialing Attempts that a control panel
can make must not exceed 15.
EMC Directive
Low Voltage Directive
Telecommunications Devices Directive