Table of Contents
Advertisement
4.3.4 PC585 / PC1565 / PC5008 / PC5010 / PC5015
Programming the Control Panel
Section(s)
[001]-[004] GSM 1000 Supervisory: choose the zone that will be used to report the 24 hour GSM 1000
supervisor y
Downloading via GSM 1000: if Downloading via cellular is to be used, choose a zone to
perform Forced Answer. Program the chosen zone as [24]. This will force the panel to answer
an incoming cellular call.
[009]
GSM 1000 Enable: program [16] into section 009. This will reserve the PGM1 output for GSM
1000 communications. Only PGM1 will support GSM 1000 operation.
[320]-[323] GSM 1000 Trouble Reporting Code: in section 320 to 323, enter the desired reporting code
for GSM 1000 Trouble reporting. Use same zone as GSM 1000 supervisory.
TLM Trouble Reporting via GSM 1000: go to section 349. Find TLM Trouble Code (via GSM
[349]
1000). Enter the desired reporting code. The Restoral is contained in section 350, this will not
be sent via the GSM 1000.
[352]
GSM 1000 Test Transmission: program the GSM 1000 Test Transmission code in section 352.
The GSM 1000 will follow the land line test transmission schedule.
[361]-[368] GSM 1000 Call Direction Options: go to sections 361 to 368. Determine which signal types
will be sent via GSM 1000. Section 380, zone light [7] dictates whether the GSM 1000 will be
used as backup or primary communications. When set to primary, the GSM 1000 will always
place a cellular call on signals so identified in Call Directions.
[390]-[392] GSM 1000 Preamble: program sections 390 to 392 with preambles (if necessary) for each
communicator outbound telephone number.
[490]
GSM 1000 Downloading Preamble: if necessary, program section 490 with the GSM 1000
Preamble for the Downloading.
[703]
Dialing Delay: program section 703 with 010. This places a necessary delay between GSM
1000 (and all other) dial attempts.
4.3.5 PC4010 / PC4020 / PC4020KT
To program the panel for GSM 1000 operation, enter the "Links 1000" section, which can be found under
System (00), Communications (04) and then Links1000 (04). Programming the following items, as
described in further detail below: Links Enable/Disable, Links telephone number, and Periodic Test
Transmission.
Programming GSM(Links) 1000 Telephone Numbers
Enter the telephone number the way it would be dialed on a telephone. The total number of digits, including
dial tone searches, must not exceed 31. Note that a "D" for a dial tone search is automatically programmed
at the beginning of the telephone number. Note: There must be a dial tone search programmed into the
telephone number for the GSM 1000 module to operate.
When a telephone number is entered, press the [#] key to save the number in the system's memory.
PC4010/PC4020/PC4020KT Telephone Entry Options Menu
Press the [*] key to enter the Telephone Entry Options Menu. Use the arrow keys to scroll through the list
of menus, and press the [*] key to select the menu displayed on the keypad screen. Or, enter [0] or [1] to
select one of the menu options described below:
[0] Save After entering a telephone number, instead of pressing the [#] key, this option may be selected
to save the number in the system's memory.
alar ms
[section
001
to
004].
Program
that
zone
as
[09].
15
Hide quick links:
Advertisement
Table of Contents
