DSC GSM 1000 Installation Manual page 14

Explanation of EDITable options:
O: xx = Old value
N: yy = New value to be entered
yy = Must be 2 digit value, e.g. O:02, N:03.
Press <ENTER> to save value and exit option.
Press <ESC> to exit option without changing the existing value.
00: Display software version.
Displays the current software version.
Line 1: Software ver.
Line 2: = 5A0100
01: Display PCB revision.
Displays the current version of GSM 1000 board.
Line 1: PCB ver.
Line 2: = 100000
02: Set number of Cell error before reporting errors to control panel.
Number of "Cell/Transceiver" problems before reporting the problem to the control panel
Line 1: Cell error
Line 2: O: xx, N: yy
Note: This value must not be "00". The factory default value is "04".
05: Ring Detect (EEPROM flag)
If enabled, the GSM 1000 can detect incoming call such as a downloading call. The RNG output will activate
when a call is incoming.
02 = Ring Detect Enabled
00 = Ring Detect Disabled
Line 1: E2prom flag
Line 2: O: xx, N: yy
08: PIN number.
Users 4 digit PIN number. Must be entered to make a call on GSM 1000
Line 1: PIN num.
Line 2: O: x, N: y
y = 1 digit value. Repeat entry until all 4 digits of your new PIN is complete.
09: 'PANIC' phone number.
Phone number to dial after the 'Panic' button is pressed.
The old phone number is displayed as
Line 1: Panic old: 123
Line 2: 4567890123456
The new phone number can be entered as
Line 1: Panic new: 123
Line 2: 4567890123456
A maximum of 16 telephone digits can be entered.
0E: Return to selection menu
0F: Exit programming mode
Note: Make sure you always exit the programming mode with the OF command. Remove the GSM 1000
programmer/PC from J1 and remove the jumper from J4.
12