Hotplate Burners - Bosch HSB738156A Instructions For Installation And Use Manual

Hotplate burners

Replacing the nozzles
Disconnect the appliance from the power supply.
1.
Remove the pan supports.
2.
Remove the burner caps (A) and burner cups (B) from the
3.
burners (C).
$
%
&
Remove the nozzle (D) and replace it with an appropriate
4.
nozzle for the new type of gas (see section "General nozzle
table").
'
Replace the gas label with the new gas label that was
5.
supplied with the nozzle set.
Place each burner cup (B) on the burner (C).
6.
Position the relevant burner cap (A) exactly on top of the cup
7.
(B).
$
%
&
Refit the pan supports.
8.
18
Setting the minimum gas flow
Switch on the gas burner.
1.
Turn the control knob for the gas burner towards the small
2.
flame setting.
Remove the control knob for the gas burner.
3.
Adjust the internal setting screw until a stable flame is
4.
burning correctly.
Loosen the adjuster screw to increase the gas flow or tighten
it to decrease the gas flow.
Check that the flame does not go out when the gas flow is
quickly changed between maximum and minimum, and vice
versa.
The setting is correct when the height of the small flame is
approx. 3 to 4 mm.
Refit the control knob for the gas burner.
5.