New Buck Corporation 80ZC User Manual page 15

Electrical procedures: The ZC-80 Cabinet is not pre-wired; an
electrician must wire the Cabinet into the home wiring. system
using No. 14 AWG (with ground wiring) as minimum in accordance
with local wiring codes. (See Figure 9)
1. Remove receptacle cover.
2. Remove receptacle from mounting box.
3. Run No. 14 AWG wire directly from house wiring in
through the Field Connector in the lower right side of the Cabi-
net.
Leave 4-6 inches of wire extending out of the box.
4.
Tighten Field Connector around wire.
5. Wire receptacle (black, white, and ground) and resecure to
mounting box.
6. Replace receptacle cover.
FIGURE 9
GROUND HOUSE WIRING TO STUD
POI'lER HOOK-UP
13
TO HOUSE
WIRING