CAUTION! Refer to chimney
manufacturers instructions for
assembly and disassembly of
chimney parts.
Be sure to
follow chimney instructions for
proper clearances to combusti-
bles and proper air spacing
required.
f f i - - - Chimney Cap
0--\.--1-
Storm Collar
---:f--
Roof Flashing
-+
Chimney Pipe
,.....e;~~"'-7"'5..-s-'lt-ttt1--
Use Fire Code Sheet Rock
-"'C-~7"''-?.-s-'S1'f--i-H-tt+f--
Met al Fire Slop
NOTE:
A Double Header must be used on a
load bearong ....all as illustrated in
F.gure
3.
2" • 4" Studding
"-':H+f--t-+++H+--
A Single Header must be Installed
above cabinet.
Vert.cal 2" • 4'''s must be turned flat.
NOTE:
Finished wall must be 2"
in front of face of Z.C.
Cabinet (without hood
trim attached) .
WARNING! Install the hearth
protector only as specified.
The hearth extension must
extend a minimum of 16" in
front of the fireplace opening
and must be 47 1/2" wide mini-
FIGURE 8 CORNER LOCATION FRAMING
10