Lexus LX 570 2016 Service Manual page 448

448
5-6. Using the other interior features
Programming a rolling code system
■
If your device is rolling code equipped, follow the steps under the heading
"Programming HomeLink
Locate the learn button on the ceiling mounted garage door opener motor.
1
The exact location and color of the button may vary by brand of garage
door opener motor.
Refer to the operation manual supplied with the garage door opener motor for the
location of the learn button.
Press the learn button.
2
Following this step, you have 30 seconds in which to initiate step 3 below.
Press and hold the vehicle' s programmed HomeLink
3
onds and release it. Repeat this step once again. The garage door may
open.
If the garage door opens, the programming process is complete. If the door does
not open, press and release the button a third time. This third press and release will
complete the programming process by opening the garage door.
The ceiling mounted garage door opener motor should now recognize the
®
HomeLink
Repeat the steps above to program another rolling code system for any of
4
the remaining HomeLink
Programming an entry gate (for U.S.A. owners)/Programming all devices in
■
the Canadian market
Place your transmitter 1 to 3 in. (25 to 75 mm) away from the surface of the
1
®
HomeLink
Keep the HomeLink
Press and hold the selected HomeLink
2
Repeatedly press and release (cycle) the device' s remote control button for
3
two seconds each until step 4 is completed.
When the indicator light on the HomeLink
4
to flash rapidly, release the buttons.
Test the operation of the HomeLink
5
button. Check to see if the gate/device operates correctly.
Repeat the steps above to program another device for each of the remain-
6
ing HomeLink
LX570_OM_OM60N01U_(U)
®
" before proceeding with the steps listed below.
signal and operate the garage door.
®
buttons.
.
®
indicator light in view while programming.
®
®
buttons.
®
button for 2 sec-
®
button.
®
compatible transceiver starts
by pressing the newly programmed