Philips 26MF605W/17 Service Manual page 25

8. Click Next , bring up Fig. 22.
- Click Finish to exit the Step window.
- Serial number can be filled up at this moment (for example,
26MF605002).
NOTE: You must modify the Serial NO. In step 9, otherwise the Serial NO.
In OSD Couldn't be modified correctly.
Step 5: Write DDC data
1. Configuration should be as Fig. 23. And press OK.
2. Access Factory Mode
1). Turn off monitor.
2). Press power "Power " button.Then quickly push " Volume -"
and " Volume ",and hold this two buttons,then the screen
comes out "Waiting For Automatic Adjustment ",then the screen
will be black for one second ,untill comes out "Windows screen"]
=> then release this two buttons, then press "Menu" button, wait
until the OSD menu with Characters "F1/FL1 NAFTA V0.91.1
041124ADJUST" (below OSD menu) come on the Screen of the
monitor (see Fig. 24).
3) Push Menu to exit OSD menu. " "
DDC Instructions
4). Click
the screen will be black for 2-3 seconds,then the screen recovers,
and "ATTENTION NO VIDEO INPUT"will come on the screen of the
monitor,wait for 20-30 seconds ,DDC data will be finished Writing.
Step 6: Save DDC data
Sometimes, you may need to save DDC data as a text file
for using in other IC chip. To save DDC data, follow the
steps below:
1. Click
bar and give a file name as shown in Fig. 25.
The file type is EDID46 file (*.ddc) which can be open in
WordPad. By using WordPad, the texts of DDC data & table
(128 bytes, hex code) can be modified. If DDC TEXTS &
HEX Table ar completely correct, it can be saved as .ddc flie
to re-load it into DDC IC for DDC Data application.
Fig. 22
2. Click Save.
Step 7: Exit DDC program
Fig. 23
Pull down the File menu and select Exit as shown in Fig. 26.
Step 8: Turn off the monitor, exit the factory mode.
Fig. 24
Factory Mode
Indicator
26MF605W/17
(Write EDID) icon from the tool bar to write DDC data. then
(Save) icon (or click "file"-> "save as") from the tool
Fig. 25
Fig. 26
25
Go to cover page