Table of Contents
Advertisement
DG-104SH VoIP Station Gateway
5
Using The Boot Menu
The DG-104SH VoIP gateway features a Boot Menu, which is described in this chapter.
To access the Boot Menu, you must first make sure the console is connected to the Diagnostics port (an RS-232 port
with a 9-socket D-shell connector and DCE-type wiring) and the appropriate cabling for the connection is being
used. Please see the previous chapter, "Configuration," for additional information. Next, power the device on by
simply plugging it in. You will see the POST test and the boot up process. During this process, press <Ctrl+C> to
reach the Boot Menu. If the boot up process has proceeded too far and you did not reach the Boot Menu shown
below, unplug the device, plug it back in (to restart the boot up process), and press <Ctrl+C> until the Boot Menu
appears.
Boot Menu---Opening screen
Configure IP
This screen allows you to enter information necessary for the initial configuration of this device.
Use the <Tab> key to highlight the first menu item on the Boot Menu, Configure IP, and press <Enter>. The IP
Configuration screen will be displayed:
Advertisement
Table of Contents
