Wireless Card Access Setup - NETGEAR WPNT834 Reference Manual

Reference Manual for the RangeMax 240 Wireless Router WPNT834
c. If no Device Name appears, you can type a descriptive name for the computer that you are
adding.
d. When you have finished entering the MAC address, return to the Wireless Access List
menu by clicking the Add button.
e. Repeat steps a - d for each wireless computer.
f. Click the Turn Access Control On box to enable Access Control.
g. Click the Apply button to save changes and return to the Wireless Settings page.

Wireless Card Access Setup

The Wireless Card Access Setup screen is invoked by clicking Add on the Wireless Card Access
List menu (see "Wireless Card Access List" on page
Figure 8-3
Program the Wireless Card Access Setup menu as follows:
• Available Wireless Cards—the Available Wireless Cards list displays any available wireless
computers and their MAC addresses.
If the wireless computer appears in the Available Wireless Cards list, you can click on the
radio button of that computer to capture its MAC address. If your wireless computer is not
displayed, make sure that the computer is configured correctly, and then click on the Refresh
button to update the available list of wireless computers. If the wireless computer is still not
displayed, then follow the instructions below on how to manually setup the wireless
computer's MAC address.
8-4
8-3):
v1.0, November 2005
Advanced Configuration of the Router